166 Con?¬?guring Cisco IOS IPS from the SDM
Ensure that the Create IPS tab is shown. To activate IPS with the default signature
parameters, click the Launch IPS Rule Wizard button to display the window in Figure
6-25. Click Next to proceed to the Select Interfaces page, shown in Figure 6-26, which
allows you to choose the interfaces as well as the direction in which IPS rules will be
applied.
Figure 6-25 IPS Policies Wizard
Con?¬?guring Cisco IOS IPS from the SDM 167
Figure 6-26 Select Interfaces??”No Interfaces or Directions Chosen
After you have chosen your interfaces and the appropriate direction (inbound or outbound),
as shown in Figure 6-27, the IPS should be applied. Click Next to advance to the SDF
Locations page, shown in Figure 6-28.
Figure 6-27 Select Interfaces??”Interface and Direction Chosen
168 Con?¬?guring Cisco IOS IPS from the SDM
Figure 6-28 SDF Locations
From the SDF Locations page, you can click the Add button to add a signature location. You
can also use a built-in signature as a backup. The built-in signature is enabled by default;
uncheck the check box if you do not wish to do this. Figure 6-29 shows the dialog box that
appears for you to add a signature location. After you specify the SDF location, click OK
to be returned to the SDF Location page, and then click Next to continue.
Pages:
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135