5. Once the hard drive is removed, unclip the screen from the logic board (see Figure 9-31).
Use the brown clip as needed.
6. Notice the six Phillips-head screws??”three on each side??”that hold the front panel of
the iPod to the frame. Remove all six screws (see Figure 9-32).
Figure 9-29: Remove the audio jack cable.
Figure 9-30: Remove the hard drive.
Figure 9-31: Unclip the screen. Figure 9-32: Remove the screws.
Screw
9 134 iPod Repair QuickSteps Does Not Compute: Replacing the Logic Board
PC QuickSteps Getting to Know Your PC 135
10 9 8 7 6 5 4 3 2 1
7. Separate the front panel of the iPod from the screen and the logic board (see
Figure 9-33).
8. Pull the screen out of the logic board (see Figure 9-34).
9. Push the logic board out of the metal frame. There is a little piece of the ribbon cable
from the Click Wheel stuck to the metal frame; you need to pull this up. Note also that
the logic board is held down with adhesive (see Figure 9-35).
Figure 9-33: Remove the front panel of the iPod.
Figure 9-34: Remove the screen.
Figure 9-35: Remove the logic board from the frame.
Pages:
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181