Figure 9-11: Remove the T6 Torx screws.
Figure 9-12: Release the scroll wheel??™s connector.
Figure 9-13: Remove the logic board. Figure 9-14: Unclip the screen.
Screw
9 128 iPod Repair QuickSteps Does Not Compute: Replacing the Logic Board
PC QuickSteps Getting to Know Your PC 129
10 9 8 7 6 5 4 3 2 1
12. Carefully unplug the connector holding the screen to the logic board (see Figure 9-15).
13. Connect the screen to the new logic board.
14. Place the new logic board in the iPod, and screw in all eight T6 Torx screws.
15. Plug in the scroll wheel??™s ribbon cable.
16. Reattach the hard drive connector, and place the piece of blue rubber where you found it.
17. Slide the hard drive into place.
18. Plug the battery into the new logic board, and place the battery on top of the hard drive.
19. Put the iPod back together.
Replace the Logic Board
in a Third-Generation iPod
To replace the logic board in a third-generation iPod:
1. Open the iPod according to the instructions in Chapter 3.
2. Unplug the audio jack from the logic board.
3. Slide the hard drive from the hard drive connector, and remove the hard drive from the
iPod (see Figure 9-16).
Pages:
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176