Figure 9-4: Remove the piece of rubber to
expose the fourth T6 Torx screw.
Figure 9-5: Remove the T6 Torx screws.
Figure 9-6: Remove the logic board. Figure 9-7: Unclip the screen.
Screw Screw
9 126 iPod Repair QuickSteps Does Not Compute: Replacing the Logic Board
PC QuickSteps Getting to Know Your PC 127
10 9 8 7 6 5 4 3 2 1
10. Find the connector for the screen underneath the Click Wheel. Carefully unplug this
connector with your iPod-opening tool or small flat-headed screwdriver (see Figure 9-8).
11. Connect the screen to the new logic board.
12. Connect the four white clips, and make sure they??™re holding the screen in place.
13. Fasten the four T6 Torx screws to the new logic board.
14. Slide the hard drive into the hard drive connector.
15. Plug the battery into the new logic board.
16. Put the iPod back together.
Replace the Logic Board in
a Second-Generation iPod
To replace the logic board in a second-generation iPod:
1. Open the iPod according to the instructions in Chapter 3.
2. Pull the battery from the back of the hard drive.
Pages:
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174