Open the iPod according to the instructions in Chapter 3.
2. Pull the battery from the back of the hard drive (see Figure 9-1). There is adhesive
holding it down.
3. Unplug the battery from the logic board (see Figure 9-2).
4. Carefully slide the hard drive from the orange hard drive connector.
5. Pull the hard drive from the iPod (see Figure 9-3).
6. Find the four T6 Torx screws in the logic board. A large piece of rubber covers one of
them. Remove this piece of rubber to expose the fourth screw (see Figure 9-4).
7. With your T6 Torx screwdriver, remove all four screws (see Figure 9-5).
Figure 9-1: Pull the battery from the hard drive.
Figure 9-3: Pull out the hard drive.
Figure 9-2: Unplug the battery.
9
iPod Repair QuickSteps Does Not Compute: Replacing the Logic Board 125
126 PC QuickSteps Getting to Know Your PC 1 2 3 4 5 6 7 8 9 10
8. Remove the logic board from the bottom of the iPod (see Figure 9-6).
9. The screen has four white clips: two on each side of the logic board. These clips hold
the screen in place. Disconnect them (see Figure 9-7).
Pages:
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173