This is the ribbon cable on the top.
Figure 5-29: Remove the T6 Torx screws.
Figure 5-30: Unclip the Click Wheel??™s ribbon cable.
Figure 5-31: Unclip the
screen??™s ribbon cable.
Screw Screw
Connector
5 70 iPod Repair QuickSteps Can??™t See a Thing: Replacing Broken Screens
PC QuickSteps Getting to Know Your PC 71
10 9 8 7 6 5 4 3 2 1
9. Remove the logic board from the iPod (see Figure 5-32).
10. Pull the screen from the iPod (see Figure 5-33).
11. Put the new screen in place.
12. Put the logic board back in.
13. Connect the new screen to the logic board.
14. Reconnect the Click Wheel to the logic board.
15. Replace all the T6 Torx screws.
16. Plug the battery back into the logic board.
17. Replace the black tape over the hard drive connector.
18. Plug the audio jack back in.
19. Put the iPod back together.
Replace the Screen in an iPod Video
To replace the screen in a fifth-generation iPod:
1. Open the iPod according to the instructions in Chapter 3.
2. At the bottom of the unit, find and disconnect the ribbon cable from the battery
(see Figure 5-34).
Pages:
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112