These clips hold
the screen in place. Disconnect them (see Figure 5-8).
10. Find the connector for the screen underneath the scroll wheel. Carefully unplug this
connector with your iPod-opening tool or small flat-headed screwdriver (see Figure 5-9).
Figure 5-6: Remove the T6 Torx screws.
Figure 5-7: Remove the logic board.
Figure 5-8: Unclip the screen.
Figure 5-9: Unplug the screen from the logic board.
Screw
5 62 iPod Repair QuickSteps Can??™t See a Thing: Replacing Broken Screens
PC QuickSteps Getting to Know Your PC 63
10 9 8 7 6 5 4 3 2 1
11. Connect the new screen to the logic board.
12. Connect the four white clips, and make sure they??™re holding the screen in place.
13. Screw in all four T6 Torx screws to the logic board.
14. Slide the hard drive back into the hard drive connector.
15. Plug the battery back into the logic board.
16. Put the iPod back together.
Replace the Screen in
a Second-Generation iPod
To replace the screen in a second-generation iPod:
1. Open the iPod according to the instructions in Chapter 3.
2. Pull the battery from the back of the hard drive.
Pages:
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106